or change tail light fluid? Im baffled and to lazy to get a shop manual!
Anybody know how ta fix a loose muffler bearing?
The muffler bearing is located right beside the hognozer gear. To replace it you have to use a bearing stretcher to get it off the wiggling pin. (The wiggling pin connects to the wobbling box)
The tail light fluid is the same basically as the headlamp fluid. You just need to be extra careful to not get the halogen fluid because it will melt the lenses.
The biggest problem I ever experienced was rotating and balancing the air in the tires. Seems when it went through my air recyclers it got so thin that it just wouldn't stay in the tires. Also I wasn't aware that you had to rotate the valve stem caps when you rotated the and balanced the air in the tires.
Anybody know how ta fix a loose muffler bearing?
You have to remove the flux capacitors to get at them. While you have the exhaust system down, you might as well go into the engine and upgrade the piston return springs.
Is there special tail light fluid available? I have always just used blinker fluid, which is always on hand because the oscillations require more frequent changes than in the tail light.
Before you can touch the muffler bearing, you must first take the pressure off the Kanuter valve. Not doing so will strip the valve guide bolts resulting having to get a Holmes head and shaft kit (very long one I'm told).
Is this on that old used bart? -or theAwesome ATB camoflage model No Quarter told me about?
Either way, its money and time down the drain.
I saw a fiend clear the air the other night,... all it did was fan the flames.
-just tryin' to help...
Each one of these answers contain at least a part of the correct answer, do the math and you wont need a Manual, your wife should have no problem figuring it out, as we all know you are to lazy,all you need to do is sit back and tell her what spanner to use and when to use it.
You go to Pep Boys or Auto Zone and buy a Knortner. The instructions tell you how to do almost anything. You might also consider a Frammis, but they are a lot more expensive, and unless you are a professional mechanic, they are difficult to learn how to use.
To change tail light fluid, remove the lens, empty it out, leave it out in the rain overnight, then quickly mate it up to the fitting before you spill too much. Don't forget to add some of that stuff u bin smokin'. ;-)
the tools are not avail to general public but they can be ordered from the steam holder shoppe//they also send buckets of steam fedex along with the proper muffler bearing adjusters and spanners
Yer killin' me. Everyone knows that muffler bearings just get replaced when they are loose. Gotta run, need to change the magic smoke in my wiring harness.
They are all fixed with the same tool as used to fix the loose nut behind the wheel.
You'll need a metric framistat and a left-handed micrometer.
It's too lazy, not to lazy. You are too lazy to spell!
Locktite? ;-)
Don't forget its a left hand thread so use the correct left handed spanner
reminds me of snipe hunting.
